do not recommend controlling the remote input
via the ignition switch to avoid pop noise during
turn on/off.
If the
Highlevel Input
is used this input does not
need to be connected as long as the car radio
has BTL output stages.
6. Connecting the loudspeaker outputs
The loudspeaker outputs can be connected
directly to the wires of the loudspeakers.
Never connect any of the loudspeaker cables
to the chassis ground as this will damage your
amplifier and your speakers.
If you connect two loudspeakers in parallel
ensure that they are correctly connected (in
phase), i.e. plus to plus and minus to minus.
Exchanging plus and minus causes a total loss
of bass reproduction. The positive terminal is
indicated on most speakers. The minimum load
impedance must not be lower than 1 Ohm, oth-
erwise the amplifier protection will be activated.
Examples for speaker configurations can be
found on page 17 et sqq.
16
Installation
