PREZONE444
- Multizone and rackable Mixer/Pre-amplifier with 8 inputs and 4 outputs
English
Page 7
REAR PANEL
1
Power input
Connect here the supplied IEC power cord, then
connect the other end to an electrical outlet after having
checked the voltage.
2
DC24V and LINK OUT connectors
The PREZONE444 might be set up in a public place and
used as an alert center in case of emergency. To this
effect, it features a 24V back-up power supply unit.
More devices can be daisy-chained via the LINK OUT
output.
3
REMOTE MIC
Allows you to connect the MIC-DESK4 announcer.
Thanks to your MIC-DESK4, you can individually select
each zone for public announcements.
4
REMOTE INPUT
Allow you to connect the remote wall-controllerWP-1.
Your WP-1 allows you to send a microphone or line
signal to each zone and adjust the level of each zone.
5
CHANNEL 1 to 8 knobs
Allows you to adjust input soundlevels.
They have a range of -50 dB to -6 dB for microphones
and of -30 dB to +14 dB for line levels.
6
PRIORITY switch
When activated, allows you to give priority to channel 1
, it acts like a talk-over and interrupt the signals of
non-priority channels.
7
PHANTOM switches
Allows you to add a +15V DC phantom power supply
to microphone channels 2 to 4 in order to connect
electrostatic microphones.
Channel 1 phantom power supply is independent and
+24V DC.
8
Inputs
Inputs are as follows:
-Inputs 1 to 4: Micros via balanced XLR plugs line mono
via Jack TRS (balanced).
-Inputs 5 to 8: Mono lines via RCA plugs and Mono
lines via unbalanced Jack.
9
LINE Outputs
Connect here an amplifier in order to power up speakers.
The signal level sent to these outputs can be adjusted
via the front panel and LEVEL knobs of zones OUTPUT
1 to 4.
10
MUTE and MUTE ALL sockets
These 2-pin sockets allow you to connect a switch to
mute all channels at once, or individually.
1
10
2
3
5
8
7
6
4
5
9