Audionet PRE, Руководство пользователя, Страница: 3 / 9

To prevent any negative influence on the signal, PRE has no regular
tape monitor loop or a rec out selector.
For recording please connect the inputs of your recording system, like
DAT or tape-deck with the monitor outputs (6) of PRE. When the
recorder is connected to the monitor outputs, for playing back you
must use inputs No. 6 of the PRE.
When input No. 6 is selected and active, the monitor outputs are
always switched off. This is necessary to prevent destructive
oscillation of PRE and recorder. Therefore Input No. 6 can not be used
for a signal source, which should be recorded.
When inputs No. 1 to 5 are selected, the monitor outputs are always
on. You are free to use these inputs for playback, when the recorder is
not connected to the monitor outputs or the recorder inputs are
connected elsewhere.
In combination with Audionets AMP I or / and DAC the PRE can
switch on and off the whole system. Please connect the Audionet link
(7) on the rear with a Toslink optical fibre cable to the Audionet link
of AMP I or / and DAC.
II) Switching on and off the mains
PRE is designed as a stand by-unit. To bring PRE into the stand by-
state, please press the mains power switch (4) on the rear. PRE will be
in the stand by-state displaying "Audionet".
To switch off the mains is only necessary in cases of longer absence
like holidays. For switching off please press again the mains power
switch on the rear. Looking from above, the switch now shows you a
"0" and the display turns off.
NOTE:
PRE is a microprocessor controlled unit. Due to this, all systems
connected with the outputs must be off and powered down when
PRE is to be switched on or off the mains at the rear. Otherwise
PRE could destroy your power amps and loudspeaker systems.
recording systems
Audionet-link