Audionet AMP V, Руководство пользователя

Страница: 15 / 27

15
6.5 AutoStart function
If the AutoStart function is active, the AMP starts up automatically to
normal operating mode right after the unit is connected to mains power
(e.g. by operating the mains switch 9 on the back panel). Use this option
to start up the AMP automatically using a timer device. For further details
please refer to section '
Set AutoStart ' on page 22.
6.6 Auto On/Off function
Your Audionet AMP is equipped with a multi-stage input signal detection
circuit (Auto On function). If an input signal is detected at the input
(Cinch or balanced (XLR)) crossing the user selectable threshold the
AMP will switch on automatically. For further details please refer to sec-
tion '
Set Auto On ' on page 21.
Note
·
Due to security concerns the Auto On function will only be available
after first manual switching on.
·
Because of the nature of stereo or multi-channel signals it may occur
that the AMPs in your setup will switch on at a different point of time
according to each input signal.
·
Operate the AMP as usual. Of course, you are still able to switch
on/off the unit manually.
The AMP will shut down automatically (Auto Off function) when no
input signal is detected for a user selectable time (30 seconds up to 2
hours). To activate and setup this feature please refer to section '
Set Auto
Off ' on page 22.
6.7 Warm Up Countdown
While you are absent the AMP can switch on automatically after a prese-
lected time (15 minutes up to 99 hours and 45 minutes) and is then pre-
heated and ready for a listening session when you get back. To setup the
countdown clock press the
power
key on the front panel longer than 2
seconds (= long keystroke) while the AMP is in stand-by mode. The dis-
play shows:
WARM UP IN :
01 hour 15 min
The cursor marks the digit of the countdown time to edit. A long key-
stroke moves the cursor one digit to the right.