Audionet AMP V, Руководство пользователя

Страница: 14 / 27

14
6.3 Mains phase detection
The correct polarization of mains is important for reasons of audio clarity
and stability. Please connect the mains cord that the 'hot' pin of the wall
outlet is connected to the pin marked '
PHASE ' 7 of the mains input 8
on the back panel. The AMP recognizes the incorrect polarization of the
mains plug automatically. Right after switching on the unit from stand-by
mode by pressing the
power
key on the front panel the following mes-
sage appears in the display in case the mains polarization is incorrect:
Attention: Mains
Phase incorrect!
If you read the above message, power down the unit by pressing the
power key. Please wait until the display no longer reads
DISCHARGING NOW
please wait...
Disconnect the AMP from mains by operating the mains switch 9 . Now
pull the mains plug and re-insert it into the mains socket rotated by 180°.
If you switch on the unit again, the warning should not appear now.
Important
·
If the AMP issues the mains polarization warning or no warning at all
for both positions of the mains plug, check the connection to earth of
your mains socket and mains cord.
You have to ensure a stable
connection to earth for the mains phase detection of the AMP to
work correctly!
6.4 Using Audionet Link
If your AMP is connected to an Audionet pre amplifier via 'Audionet
Link', use the remote control of the pre amplifier to automatically switch
on/off the AMP (and all other Audionet units also connected via 'Audio-
net Link').
For setting up the necessary connections please refer to section ' Audionet
Link ' on page 12.
Note
·
The 'switch on' signal is issued to any further Audionet units daisy
chained to the 'Audionet Link' output of your AMP with a little delay
to avoid all units switching on at the same moment, which could
cause an overload of your mains fuse.
·
Independently from the 'Audionet Link' interface, you can switch
on/off your AMP at any time by using the
power key on the front
panel.