AUDIOLINE DECT5500, Руководство по эксплуатации

Страница: 42 / 72

- Setting Up -
42
2. Setting up
2.1 Safety notices
NOTICE! Before switching on, do not fail to read the safety notices on of the beginning
of these instructions.
2.2 Checking the contents of the package
The package should contain:
one base station
one supply cable
one handset with Akkupack one belt clip
one telephone connection cable one set of directions for use
2.3 Connecting the base station
Set up the AUDIOLINE DECT5500 within reach of a telephone socket and an electricity
supply socket.
1. Insert the connector on the lead from the transformer plug in the socket on the
underside of the base station and insert the transformer plug in a 230V supply socket
installed in accordance with regulations. The base station transformer plug must
always be connected. For safety reasons, use only the transformer plug supplied.
2. Connect the telephone cable supplied between the telephone socket and the
corresponding socket on the underside of the base station. Only use the new
telephone cable supplied.
3. Press the two cables into the two cable channels leading to the rear of the base
station.
2.4 Exchange the batteries
If you ever have to change the rechargeable batteries, use
only rechargeable batteries, type AAAA 1.2 Volt, 120mA or a
Ni-MH 2.4V, 300mA battery pack. To fit the batteries into a
handset, press down on the upper edge of the battery
compartment cover and slide it downwards. Then carefully
remove the battery holder. Please do not pull too hard on the
battery holder to avoid breaking the connecting wires.
Remove the used batteries and then fit the new batteries into
the battery holder. In doing so, be careful to ensure that the
polarity is correct. When using a battery pack, please be
careful of the contacts on the side and take note of the
inscription on the battery pack. Replace the battery holder in the handset and close the
lid of the battery compartment.
Important notice: Place the handset on the base station, with the display facing
forwards, for at least 16 hours. If the batteries are not properly charged, the telephone
may fail to function correctly. While the handset is charging, the battery capacity symbol
in the display will blink. The
indicator lights as soon as the handset is placed in
position.