P. 6
AUDIOLAB Live AN Split -
English version
or the mono input signal is routed to the
stereo main output bus, please use this knob
to determine the proportion between the left
and the right.
10.
POWER SWITCH & POWER LED
This switch
turns on/off the unit. When the unit is pow-
ered on,the LED will light up.
Rear Panel
11.
FUSE HOLDER
Before you attempt to connect
and operate the unit, please make sure that
your local voltage matches the voltage on the
fuse-holder cover. Caution: The fuse protect-
ing the AC supplies circuits of the unit. The
fuse can only be changed by a qualified techni-
cian, in the event of a foult or changing the
supply voltage. If the fuse continues to blow
after replacing, discontinue use of this unit
before repaired.
12.
AC inlet
This connector is meant for the
connection of the supplied main cord. Do not
insert power cable into the unit until the volt
-
age has been correctly set. Do not plug power
cable into AC power until voltage has been
correctly set.
13. MAIN INPUTS
These two XLR balanced
connectors are used to input the main stereo
signal. In SPLITTER mode, it can be split into
each mono channel output.
14. MAIN OUTPUTS
These two XLR balanced con
-
nectors are used to output the main stereo
signal. By depressing the MAIN LINK, It can be
linked with the MAIN IN directly.
15.
INPUT for the mono channel
For Channel
1~4, use the XLR balanced connectors to in
-
put the mono signal, while, for Channel 5~6,
please use the TRS type.
16.
OUTPUT for the mono channel
For Chan
-
nel 1~4, use the XLR balanced connectors to
output the mono signal, while, for Channel
5~6, please use the TRS type.