4: Controls and functions - 2
Page 6
8.Wi-Fi LED State Indicator
Device States
Initialization Mode
Standard Setting Mode
WPS Mode
Network Connecting
Wi-Fi Network Connection
Wired Network Connection
LED States
Fast-flash
Slow-breathe
Double-flash
Slow-flash
Brightly lit
Off
3.Standby Button
When in Standby mode, the power LED will glow in dark red. There are various standby mode
options available. You can activate these options by holding the Standby button for 4 seconds and
then;
- ‘Never in auto-standby' mode: short press the Standby button when it flashes once. By default,
- ‘Auto-standby after 20 minutes': short press the Standby button when it flashes twice.
- ‘Auto-standby after 1 hour': short press the Standby button when it flashes thrice.
4.Fuse
The fuse specification
:
220~240V (UK, China, etc.) T630mAL 250V Slow Blow
100~120V (America, Japan, etc.) T1AL 250V Slow Blow
5.AC Mains Socket
You can select between AC mains voltages 115V or 230V using the switch on the underside of the
case. Before connecting the unit to AC mains power, please check that the voltage switch is set to
match to your AC mains voltage.
6.AC Power Switch
Before connecting the AC power cord to the 6000N, please make sure the Power Switch is in the Off
position. Switch it to the ON position after connecting the unit to the AC mains.
7.Wi-Fi Antenna
DTS Play-Fi is compatible with any router which is authenticated to Wi-Fi standards. We recommend
the use of 802.11n or better which enables 2.4GHz and 5 GHz transmission frequencies. If you have
the option, 5GHz connection will give the most stable performance.
9.Wi-Fi Setting Button
Press and hold the Wi-Fi Setting Button for 4 seconds to enter WPS mode. Press and hold for 8
seconds to enter the Standard setup mode.
10.Ethernet Port
Use a suitable cable to plug the Ethernet Port to the LAN port of a wireless router for wired
connection.
11.Update Interface
This USB interface is only to be used for upgrading the internal firmware. It cannot be used for USB
media sources.
Upgrade method:
Put the Audiol
ab upgrade file on a USB memory stick and insert into the Update
Interface. Hold down the Standby Button on the front panel, turn on the power switch then release
the button. The red LED on the front panel will flash as the upgrade takes place. After the upgrade
completes, a 'relay' sound will be heard and the red LED glows steady and dimly. You can then
unplug the USB stick and operate the 6000N.
12.USB Control Interface
If you are using 6000N with the Audiolab 6000A amplifier, connect this USB Control Interface to the
6000A 'Update' Interface with a USB B data cable. You can then use the Play-Fi APP to control the
listening volume.
Please note: the USB Control Interface cannot be used to link to a PC or output digital music data.
13.12V TRIG Interfaces
Two standard 12V trigger interfaces are provided to allow the 6000N to be switched off and on
remotely. Connect the 12V trigger source equipment to the 'IN' interface. The 'LINK' interface can
be used as an output to daisy-chain the 12V trigger.
14.Digital Signal Output Interface
Two Digital Signal outputs are provided - one COAX and one OPT (Optical). The maximum output
resolution of the PCM digital signal is 24 bit/192kHz.
15.Analogue Signal Output Interface
Use this stereo output to connect to an amplifier or other device that accepts an analogue input
using a shielded RCA cable.
6000N Play is set in this mode.
