14
Quick Start Guide
ACR-1 Dash Control Installation
The AudioControl ACR-1 dash control is a remote level for your
LC-6.1200 amplifier. It may be mounted under the dash using its own
enclosure, or through a custom hole in the dash. The knob should
be within reach of the driver, and in a spot where the LED is plainly
visible. Disconnect the vehicle b12V and Ground connections
before installation.
Dash Bracket Installation:
The dash control mounts with four
screws, which attach to the underside of the dashboard. Slide
under the dash and place the dash control in its mounting po-
sition, mark the best mounting holes, carefully drill pilot holes,
and secure with screws.
Custom Installation:
For that custom, finished look, the dash control
can be flush-mounted directly on the dashboard (or anywhere
else). Disassemble the ACR-1 from its enclosure.
Top Lid Removal
The top lid must be removed to gain access to the controls, and then
put back on again to protect the controls from dust bunnies.
Removal Procedure
1. Locate the two screws that hold the straight edge of the lid onto
the connector side of the amplifier.
2. Use the supplied hex key to loosen both screws just enough
until this edge of the lid can lift freely up just a little. (There is no
need to remove the screws all the way, in case you lose them.)
3. Slide the lid toward the heatsink fins just a tad, before further
lifting the straight edge of the lid about 2”, then disengage the
remaining two points of contact (under the wavy edge).
4. Place the lid in a safe and handy place, ready for the time when
you have finished adjusting the controls to your immense satis-
faction, and just before Chivers brings tea and sandwiches.
