AudioControl Concert avr-6, Руководство пользователя

Страница: 29 / 50

®
29
n
avIgatIng tHe
s
etup
M
enus
INSTALL TIP
*
C
onCert avr
-
8 /
avr
-
6
Control - Front Panel and IR control are always active. This control set-
ting defines the 3rd option for controlling your AVR-6 / AVR-8. You may
select between RS-232 or IP control if you have an automated control
system. Default setting is Off
Power On - This setting defines the state of your AVR-6 / AVR-8 once
the Mains Power switch has been turned off or if there was a power outage
where power turns off and then back on again. You have 3 options in this
setting:
Last State - where the unit returns to the last On or Standby state before
power was lost or the Main power switch was turned to off
Standby - where the unit comes up to Standby once power has returned
On - where the unit turns on completely once power has been restored
Auto Setup & Room Correction
Your Concert AVR-6 / AVR-8 is equipped with an Auto Setup feature that
assists in setting all of the essential speaker settings for your system, includ-
ing which speakers are present, types of speakers, crossover settings for the
subwoofer, sound level and distance compensation. It will also calculate
basic room equalization filters to offset frequency resonances caused by
acoustics and speaker placement. While there is no substitution for proper
acoustical treatments, speaker placement and theater calibration, the Auto
Setup Mode is useful for maximizing the acoustical performance of many
theaters.
Microphone Positioning
The calibration microphone that comes with Concert AVR-6 / AVR-8 is
designed to be placed in the center of your theater in the main listening po-
sition preferably at the same height as your head. Connect the microphone
jack to the “Aux” input on the rear of your Concert AVR-6 / AVR-8.
Make sure you minimize any background sounds in the theater by turning
off any fans or noisy air conditioning systems, and close all doors and win-
dows as outside sounds will negatively affect your measurement. Addition-
ally if the microphone is positioned too close to the speakers this will result
in a signal Clipping error.
Run Auto Setup - In this menu, press the “Select” button on the
front panel and the Concert AVR-6 / AVR-8 will begin generating
test tones out of each channel, a process that takes about two min-
utes. During this process the AVR-6 / AVR-8 identifies which speak-
ers are being utilized in the system and what the recommend system
adjustments are, based on the measurements.
Important Note:
Auto Setup works with 5.1
or 7.1 speaker systems. You
will need to manually set
up other types of speaker
configurations by way of
the Speaker Types, Speaker
Distance and Speaker
Levels menus discussed on
the following pages of this
manual.