AudioControl
22410 70th Avenue West, Mountlake Terrace, WA 98043 USA,
Phone 425-775-8461, FAX 425-778-3166
e-mail: [email protected]
3. Once the code sequence has been entered successfully, all 3 input LEDs will flash 3 times in a rapid fashion to confirm it has entered the IR
Learning mode. Once in this mode, the 3 input LEDs will remain lit until the amplifier is taken out of learning mode.
4. On the RTR-1 remote, press the desired function you wish to associate with the other remote. The Rialto/Bijou600 input LEDs will flash once
to indicate it is ready to learn the IR command from the other remote. For example, you could press “1” on the RTR-1 remote.
5. Press the button on the other remote that you want to associate with the function previously defined on the RTR-1. The LEDs will turn off,
indicating it has received the command from the new remote. For example, you could press a “1” on the other remote.
6. Press the button on the other remote again to confirm the command selection. The Rialto/Bijou600 will flash twice to indicate that the com-
mand is understood.
7. Repeat steps 4 to 6 for each button command you want the Rialto/Bijou600 to learn.
8. Once you are done, the amplifier will exit out of learning mode after 30 seconds of inactivity. Or, you can re-enter the number sequence
again:
3 1 2 1 3 2 3
to exit the learning mode.
Notes:
• If the Rialto/Bijou600 receives a command that it does not understand, five times in a row, it will drop out of learning mode.
•
Important:
If you have a multi-device remote, you must only use IR codes for devices that are not in your current system. Otherwise there
may be remote conflicts causing confusion, chaos and woe. For example, if you use the codes from your current TV, you will end up con-
trolling both the TV and the Rialto/Bijou600 and upsetting grandma all at the same time.
•
Pro Tip:
If you plan on using a universal remote that can control multiple devices by switching the remote’s “Mode,” then choose a mode on
the remote that you are not using. For instance, if there is an Aux mode, or VCR mode that you are not using, make that the mode for the
Rialto/Bijou 600. You can then select any random code from a manufacturer you do not have, and this will ensure no remote conflicts.
2
Rialto 600/Bijou 600 Addendum continued
