AudioCodes Mediant 500 E-SBC, Руководство пользователя

Страница: 438 / 920

User's Manual 438 Document #: LTRT-10437
Mediant 500 E-SBC
26.9 Configuring Charge Codes
The Charge Codes table lets you configure metering tones for Advice of Charge (AOC)
services for Euro ISDN trunks (see Advice of Charge Services for Euro ISDN on page
436 ).
You can configure up to 25 different Charge Codes, where each table row represents a
Charge Code. Each Charge Code can include up to four different time periods in a day (24
hours). The device selects the time period by comparing the device's current time to the
end time of each time period of the selected Charge Code. The device generates the
number of pulses on answer once the call is connected, and from that point on, it
generates a pulse for each pulse interval. If a call starts at a certain time period and
crosses to the next, the information of the next time period is used.
To assign a Charge Code to an outgoing Tel-to-IP call, use the Outbound IP Routing table.
Note: The Charge Codes table is applicable only to Euro ISDN PRI interfaces.
The following procedure describes how to configure Charge Codes in the Web interface.
You can also configure Charge Codes using the table ini file parameter, ChargeCode or
CLI command, configure voip > gw analoggw charge-code.

To configure a Charge Code:
1. Open the Charge Codes Table page ( Configuration tab > VoIP menu > GW and IP
to IP > DTMF and Supplementary > Charge Codes ).
Figure 26-6: Charge Codes Table Page
2. Configure a Charge Code according to the parameters described in the table below.
3. Click Submit , and then save ("burn") your settings to flash memory.
Table 26-7: Charge Codes Table Parameter Descriptions
Parameter Description
End Time
CLI: end-time-<1-4>
[ChargeCode_EndTime<1-4>]
Defines the end of the time period in a 24 hour format, hh . For
example, "04" denotes 4 A.M.
Notes:

The first time period always starts at midnight (00).

It is mandatory that the last time period of each rule end at