5
|
P a g e
Connecting to DC power source:
1.
Connect the open ends of the two wires on the DC power feed cable (supplied) to the DC power
source. Make sure that the wires are connected to the correct polarity (
black
wire negative;
red
wire
positive).
2.
Plug the DC power feed cable, crimped to the terminal block, into the DC inlet of one of the Power
Supply modules, located on the rear panel. Make sure that the hook on the terminal block snaps into
the groove above the inlet.
3.
Repeat the above steps for the second Power Supply module, but connect it to a different DC power
source.
