AudioCodes Media Pack MP-11x, Руководство пользователя

Страница: 601 / 650

Version 6.6 601 MP-11x & MP-124
User's Manual 44. Configuration Parameters Reference
Table 44-51: Automatic Dialing Parameters
Parameter Description
Automatic Dialing Table
Web: Automatic Dialing
Table
EMS: Analog Gateway
Provisioning >
Automatic dialing
[TargetOfChannel]
This table parameter defines telephone numbers that are automatically
dialed when a specific FXS or FXO port is off-hooked. The format of this
parameter is as follows:
[TargetOfChannel]
FORMAT TargetOfChannel_Index = TargetOfChannel_Destination,
TargetOfChannel_Type, TargetOfChannel_HotLineToneDuration;
[\TargetOfChannel]
For example, the below configuration defines automatic dialing of phone
number 911 when the phone connected to Port 1 is off-hooked for over 10
seconds:
TargetOfChannel 0 = 911, 1 ,10;
Notes:

The first index of this table ini file parameter is 0.

TargetOfChannel_Index is the port number, where 0 denotes Port 1.

This is parameter is applicable only to FXS and FXO interfaces.

For a detailed description of this table, see 'Configuring Automatic
Dialing' on page
305 .
44.11.5.11 Direct Inward Dialing Parameters
The Direct Inward Dialing (DID) parameters are described in the table below.
Table 44-52: DID Parameters
Parameter Description
Web/EMS: DID Wink
[EnableDIDWink]
Enables Direct Inward Dialing (DID) using Wink-Start signaling, typically
used for signaling between an E-911 switch and the PSAP.

[0] Disable (default)

[1] Single = The device can be used for connection to EIA/TIA-464B
DID Loop Start lines. Both FXO (detection) and FXS (generation) are
supported:

The FXO interface dials DTMF (or MF) digits upon detection of a
Wink signal, instead of a dial tone.

The FXS interface generates a Wink signal upon detection of an
off-hook state, instead of playing a dial tone.
Example: (Wink) KP I(I) xxx-xxxx ST (Off Hook)
Where:

I = one or two information digits

x = ANI
Note: The FXO interface generates such MF digits when the
Enable911PSAP parameter is set to 1.

[2] Double Wink = Double-wink signaling. The FXS interface
generates the first wink upon detection of an off-hook state in the line.
The second wink is generated after a user-defined interval (configured
by the TimeBetweenDIDWinks parameter), after which the DTMF/MF
digits are collected by the device. Digits that arrive between the first
and second wink are ignored as they contain the same number.
Example: (Wink) KP 911 ST (Wink) KP I(I) xxx-xxxx ST (Off Hook)