Audio Technica AT-ONE, Инструкция по установке и эксплуатации

Страница: 9 / 18

System Operation
Connecting the receiver:
Plug the DC 12V 500mA power supply into the
power connector on the back of the receiver.
The power connector is supplied with
interchangable UK and EU adaptors.
Connect the receiver output to an audio mixer
or amplifier input, using a standard audio cable
with 3-pin XLR or 6.35mm Jack connectors.
Never use balanced and unbalanced audio
outputs at the same time, this may cause
signal loss or increased noise.
Set the attenuation for mic or line input.
Two-position switch adjusts the audio output
attenuation to 0 dB or -20 dB. The factory
setting is 0 dB.
Line Mic