5
System Operation
Connecting the Receiver
Plug the DC 12V 500 mA power supply into the power connector on the
back of the receiver. The power connector is supplied with interchangable US
and EU adaptors.
Connect the receiver output to an audio mixer or amplifier input, using a
standard audio cable with a 3-pin XLR or ¼" connector. Never use balanced
and unbalanced audio outputs at the same time, this may cause signal loss or
increased noise.
Set the attenuation for mic or line input. The two-position mic/line switch
adjusts the audio output attenuation to 0 dB (line-level) or -20 dB (mic level).
The factory setting is 0 dB.
System Setup
For best operation the receiver should be at least 1 m above the ground and
at least 1 m away from a wall or metal surface to minimize interference. The
transmitter should be at least 3 m from the receiver, as shown in the diagram
to the right. Keep antennas away from sources of RF interference.
AUDIO OUT
UNBALANCED
SQ
BALANCED
DC 12V 500mA
ANT A
ANT B
LINE MIC
AUDIO OUT
LINE MIC
UNBALANCED
SQ
BALANCED
DC 12V 500mA
ANT A
ANT B
LINE MIC
AUDIO OUT
UNBALANCED
SQ
BALANCED
DC 12V 500mA
ANT A
ANT B
LINE MIC
