8
E
N
Preparation for use
Setting pre-amplifier selector switch
This product has a built-in phono equalizer function. You can use the
product, even if you do not have a phono amplifier or connectable
equipment with a built-in phono amplifier, by connecting an active
speaker, etc.
Use the pre-amplifier selector switch to set the output, as shown below.
Connectable
equipment being
used
Position of
pre-amplifier
selector switch
Where to connect the
RCA audio cable
Device with phono
input
PHONO
Phono input jack and
ground (earth) terminal of
connectable equipment
Device without
phono input
LINE
AUX or line input jack of
connectable equipment
PC sound card
LINE
Sound card's line input jack*
1
Device with USB
input
LINE
USB input of your
computer*
2
*
1
An audio adapter (sold separately) may be required to connect the
RCA audio cable to the PC sound card's line input jack.
*
2
Use included USB cable instead of RCA audio cable to connect.
Connecting to connectable equipment (active
speakers, amplifiers, DJ mixer, etc.)
Connecting to audio source
Align the settings for the pre-amplifier selector switch and connect
the RCA audio cable to an input jack that is compatible with the
connectable equipment you are using (amplifier, receiver, active
speakers, sound card, etc.).
The RCA audio cable's red jack is for the right (R) channel, and the
white jack is for the left (L) channel.
• Depending on the equipment you are connecting, a ground (earth)
terminal may exist near the phono input jack. If this is the case,
connect to it using the ground line from the RCA audio cable. This
will help prevent a low humming noise that might otherwise be heard
during playback.
Connecting to computers with USB input
Follow the settings for the pre-amplifier selector switch to connect the
included USB cable to the USB input of your computer.
The included USB cable connects the product to your computer
without need for special drivers.
Audacity (refer to http://www.audacityteam.org for details) and other
compatible third-party recording software packages are available,
allowing you to record from the product to your computer.
• Be sure to set the pre-amplifier selector switch to the LINE position.
Connecting the power cable
Finally, after all audio connections are made, attach the included
power cable to the product. Then connect the power cable’s plug to a
convenient AC outlet.
With PHONO input*
With PHONO input*
Without PHONO input
Without PHONO input
Or LINE
connection
To outlet
To
USB port
To outlet
Connectable
equipment
(amplifier,
DJ mixer,
etc.)
