4
E
N
Part names and functions
Overall diagram
11
Speed range button
/- 10 or 20% speed range.
• +/-50% is selected by pressing both the 10 and 20 buttons
simultaneously.
12
Quartz button
Turns the pitch function on and off. When the quartz is activated
the platter will hold the RPMs at 0% pitch, regardless of the pitch
slider position and speed range control settings.
13
Pitch adjust slide control
Use in conjunction with pitch button to vary the platter’s rotational
speed. In the center detent position quartz lock is active.
14
45-RPM adapter
Adapt 7" records with large center holes to fixed center spindle
15
Feet
Adjust the level of the product.
16
Stereo output terminals
Connect the RCA audio cable. Connect it to either the amplifier's (DJ
mixer's) PHONO input jack or its line input jack. The red terminal is
the right channel and the white terminal is the left channel.
17
Ground (earth) terminal
Connect the amplifier's ground (earth) terminal to this terminal
using the RCA audio cable's ground line.
18
Pre-amplifier selector switch
If connecting to an amplifier's (DJ mixer's) PHONO input jack, set
this switch to the PHONO position. If connecting to the LINE/AUX
jack of an amplifier (DJ mixer), set this switch to the LINE position.
19
USB output
Use this output to connect your turntable to the USB input of your
computer.
20
AC inlet
Use to connect the included power cable.
1
Power dial
Controls power to the unit.
2
Dual start/stop buttons
Engages and disengages the motor/platter.
3
Platter speed buttons
Select 33 or 45 RPM platter speed. 78 RPM is selected by pressing
both the 33 and 45 buttons simultaneously; both buttons should
be illuminated.
4
Platter
Cast aluminum platter mounts directly to center spindle/motor shaft.
5
Strobe dots (on platter edge)
Operate in conjunction with stroboscopic light located under the
power dial to provide visual indication of accurate platter speeds.
6
Spindle
7
Removable stylus target light
Provides illumination directed at the stylus position for easier
cueing in low light. Easily plugs into jack on top of turntable deck.
8
Start control knob
Rotate the start control knob to increase or decrease platter start
time between 0.2 – 6.0 seconds. (Minimum setting is the quickest
start; maximum setting is the slowest start to reach selected speed.)
9
Brake control knob
Rotate the brake control knob to increase or decrease platter brake
time between 0.2 – 6.0 seconds. (Minimum setting is the quickest
stop; maximum setting is slowest.)
10
Reverse control button
Controls platter’s rotational direction.
1
2
2
12
13
14
5
7
8 9
4
6
10
3
18
20
15
15
17
19
16
11
