Audio Research LS28, Руководство пользователя

Страница: 17 / 22

17
Display Brightness
The display brightness feature offers six
different settings (including off) for the
vacuum fluorescent display on the front
panel. When the lowest setting (off) is
selected, the display will remain on for
five seconds after any button is pushed,
after which it will revert to a black screen
with a small, illuminated square in the
center to indicate the unit is powered on.
To change the display brightness, press
the ‘MENU’ button until ‘DISPLAY
BRIGHTNESS’ appears. Press the enter
button. Using the volume knob on the front
panel, or the up/down volume buttons on
the remote, change the display brightness
to your preference. Once you have selected
the appropriate brightness, there is no need
to press ‘ENTER’ or any further buttons.
Note
The remote control offers direct control
of the display brightness via two buttons
labeled ‘DISP UP’ and ‘DISP DN’. You
can choose to use these buttons as an
alternate to the settings menu.
Operation
Volume Reset
The volume reset feature tells the LS28 to
either remember the volume settings for
each individual input, or to reset them to
zero after a power off cycle. When volume
reset is set to ‘OFF’, the LS28 will also
remember settings after a power cycle.
To change the status of the volume reset,
press the ‘MENU’ button until the display
reads ‘VOLUME RESET’. Press ‘ENTER’,
and use the volume knob on the front
panel, or the up/down volume buttons on
the remote, to select ‘ON’ or ‘OFF’. Press
‘ENTER’ to choose the appropriate setting,
and ‘ENTER’ once again to confirm. The
display will read ‘OKAY’ and show the
current setting for volume reset.
Input Naming
The LS28 is pre-loaded with a selection of
names which can be assigned to the eight
inputs of the preamplifier, allowing for
easier identification of the various inputs.
When selected, the chosen input name will
display above the default name (BAL 1, SE 3,
etc.) on the normal operation screen.
To select an input name for any of the
inputs, press the ‘MENU’ button until
‘INPUT NAMING’ is displayed. Press the
‘ENTER’ button, and use the volume knob
on the front panel, or the up/down volume
buttons on the remote, to select the
desired input for naming. Press ‘ENTER’ to
engage the naming utility, and using the
volume knob or up/down volume buttons,
select the appropriate name for the input.
Press ‘ENTER’ a final time to confirm the
input name. The display will show ‘OKAY’.