Audio Pole FORCE 700, Руководство пользователя

Страница: 5 / 11

Controls & Settings
5
1 – POWER
Power ON/OFF switch. Before any action, turn the potentiometers (2) and (3) to maximum attenuation (-
∝
).
The start is protected by a 7 second delay.
2 – CHANNEL 1
Channel 1 input signal attenuator.
Increasing the level is done by turning the knob in a clockwise direction.
3 – CHANNEL 2
Channel 2 input signal attenuator.
4 – SIG
Channel 1 signal indicator.
The intensity of the Green Led varies depending on the level of the input signal.
5 – SIG
Channel 2 signal indicator.
6 – CLIP/PROT
Channel 1 clipping signal.
The red Led, provides information about the state of the input signal. Normally, it should illuminate only
occasionally. If the light stays on, the input level is too important and there is a risk of distortion. So adjust the
level with the attenuators (2) and (3) or decreases the source volume.
7 – CLIP/PROT
Channel 2 clipping signal.
8 – BRI POW
BRIDGE mode indicator power.
The two-color LED lights up green when the amplifier is powered; It turns red when the BRIDGE mode is
switched on.
Front Panel
3