VCP-015-02-x Installation & Operation Manual
Document # 540228, Rev A, 05/2003
Page 10 of 18
5.5
When running cables, avoid sharp bends and placing cables near aircraft
control cables. Maintain a MINIMUM clearance of three (3) inches from
any control cable. If wiring is run parallel to combustible fluid or oxygen
lines, maintain a separation of six (6) inches between the lines.
5.6
Bonding between chassis mounting point and airframe installation to be
<1
Ω
resistance using <50
Ω
impedance cable. No surface prep is
required due to conductive chassis finish (except front bezel).
6.0 Electrical Characteristics
6.1 Electrical
Specifications:
Electrical
Power
1A @ +28 VDC
Operating Voltage
Range
+18 to +32 VDC
Data Bus Type
AI Proprietary RS-485
Audio Frequency
Response
200 Hz to 8 kHz
Audio S/N
>37dB (NOMINAL)
Video Output
1 V
(p-p)
into 75
Ω
Playback Format
PAL, MESECAM, & NTSC
Video Output
NTSC
Video Heads
4
Infrared Signal Input
+5 VDC digital logic level
6.2
The VCP-015-02-x utilizes one (1) 15-pin connector for electrical
connections. This connector provides power, left/right audio output, data
bus control, infrared input, and eight (8) infrared strapping pins for
alternate configuration of infrared digital command codes to allow up to
eight (8) VCP-015-02-x in the same system.
6.3 Mating Connector Information
Model #
Mating Connector
VCP-015-02-1 RD15F10JVL0
VCP-015-02-2
DAMA-15S
D20418-2 Female Screwlock
BNC1 Video Output AMPHENOL 31-71013 or equivalent
