AUDIO INTERNATIONAL, INC.
2/98
7
Document #540067, Rev. IR, Model No.: RCD-02x-x & RCD-020x-40x
2.2
Unpacking & Inspection
2.2.1 Carefully open the packaging and remove the compact disc player / AM-
FM Tuner. Verify that all components have been included in the package
per the packing list. Inspect the unit for damage. Retain the packing
materials and packing list. The components should arrive in good
condition.
If damage has occurred during shipping, a claim must be filed with AI
within 24 hours and a “Return Request Authorization Number” must be
obtained from AI. Refer to the front cover of this manual for address and
telephone number of Audio International, Inc.. Repackage the unit in its
original packaging materials and return it to AI following instructions
given by the AI representative. If no return is necessary, retain the
packing materials for storage or reshipment if necessary.
2.3
Cautions & Warnings
2.3.1 All audio connections to the RCD should be shielded and properly
grounded at the source. Perform a pin-to-pin check to confirm that all
wires terminate in their proper location. It is important to do a power and
ground check on the pin connections. Ensure that power and ground are
applied only where required.
2.3.2 DO NOT connect or disconnect the unit while power is applied.
2.3.3 DO NOT remove any factory-installed screws. Damage to the unit may
result and void any warranties.
2.3.4 DO NOT load three (3) inch CDs into the unit. While attempting to load
a 3 inch CD with adapter into the unit, the adapter might separate from the
CD and damage the unit or become lodged inside.
2.3.5 DO NOT use dirty CDs or CDs colored on the data side. If you try to
play CDs that are colored on the recorded side (opposite the label), or CDs
that are dirty, they may fail to slide in or out. Also, do not put tape on
CDs and attempt to insert into the unit. This could cause failure or
damage to the unit.
