MCD-102-CH (-x), MCD-102-RU (-x)
Audio International, Inc. MCD-103-CH (-x), MCD-102-CP (-x), & MCD-104-01-x
Installation Manual
Document #540031, Rev. B, 4/2000
Page 12 of 18
display several different error codes. Refer to Section 4.0 for a
definition of these error codes.
4.0 Troubleshooting
Guide
4.1
General Troubleshooting Procedures
Many problems can be isolated with the following general techniques:
•
To verify power to the unit, r28 VDC is applied to the proper
pins on the unit. Use a voltmeter to verify correct level.
•
Reset by removing power from the unit for at least one minute and
reapply power. Verify the problem still exists.
•
Recheck all connections to the unit for security. Check all harness
runs for possible pinching. Recheck all pinouts for application
accuracy.
4.2 Troubleshooting
Chart
Problem Possible
Cause
Solution
Sound skips
CD remote unit is incorrectly
installed
CD is dirty or defective
Reinstall unit
Clean or replace CD
Disc magazine will
not lock in the
changer
CD magazine does not have
proper loading orientation
Remove the disc magazine,
press EJECT and reinsert
magazine until it is locked
securely into place
No sound
Power has not been
connected
Power to external equipment
is “off”
External equipment
incorrectly connected
28 VDC power is
present
Verify source equipment is
“on” and operational. Verify
CD remote unit and control
unit are “on”
Verify all connections per unit
instructions
Poor sound quality
Audio
controls
improperly
adjusted
Adjust the volume level
Error code E-01
Disc magazine not inserted in
the CD remote unit
Insert the disc magazine with
CD’s into the CD changer
Error code E-02
No disc is inserted in the
magazine
Remove magazine and insert
a CD
Error code E-04
CD is dirty or incorrectly
oriented
Clean CD, reinsert correctly
Error code E-99
CD changer cannot be
operated due to difficulties
Press RESET on the CD
remote unit
