DVD-401-01-x Installation & Operation Manual
Document # 540254, Rev IR, 10/2002
Page 11 of 18
6.2
The DVD-401-01-x utilizes two (2) 15-pin connectors for electrical
connections. These connectors provide power, data bus control, infrared
input, and three (3) infrared strapping pins for alternate configuration of
infrared digital command codes, respectively.
6.3
Standard configuration requires no infrared strap pins to be connected.
Each different type of AI source equipment can be configured to accept
one (1) of eight (8) different sets of infrared codes. To change the code
settings, connect one (1) of the strap pins to the strap common (never
connect more than one (1) strap pin to the strap common). Three (3)
strap pins are available to allow the infrared codes to be configured.
6.4
The video output connectors (BNC1 and BNC2) allow for proper video
output to the video distribution system.
6.5
Infrared input provides a ground reference connection (-). For optimum
infrared
signal
transmission,
this
ground
reference
connection
should connect along with the chassis ground reference connection (pin 2)
to the same ground termination location as that of the IFR-9A or IFR-485
module being utilized. If this is not possible, then the infrared ground
reference connection for the DVD-401-01-x
shall connect to chassis
ground reference (Pin 2).
6.6
The fiber optic transceiver connectors (J3 and J4) allow for proper digital
audio output to the audio distribution system.
6.7
Mating Connector Information
Model #
Connector Designator
Mating Connector
DVD-401-01-1 J1
RD15F10JVL0
DVD-401-01-2 J1
DAMA-15S
D20418-2 Female
Screwlock
DVD-401-01-1 J2
RD15F10JVL0
DVD-401-01-2 J2
DAMA-15S
D20418-2 Female
Screwlock
BNC1 Video
Output
BNC1
AMPHENOL 31-71013
or equivalent
BNC2 Video
Output
BNC2
AMPHENOL 31-71013
or equivalent
Optical Digital
Audio Output
(DVD1)
J3
ST Series optical
connector 501380-6
(AMP) or equivalent
Optical Digital
Audio Output
(DVD2)
J4
ST Series optical
connector 501380-6
(AMP) or equivalent
