Audio International, Inc.
DVD-021-0x-x Installation & Operation Manual
Document # 540125, Rev B, 12/2000
Page 18 of 31
4.0
Infrared Remote Control
ILLUSTRATION
OF TYPICAL
DVD-021-0x-x
REMOTE CONTROL
4.1
Remote Control User Special Instructions
4.1.1 In case batteries begin to lose power, all indicators will flash when
any button is pressed.
4.1.2 To replace batteries, remove the battery compartment cover on the
back of the unit. Load four (4) AAA size Alkaline Manganese
batteries ensuring the positive (+) and negative (-) terminals on the
battery ends match the markings inside the remote control unit.
Service life of the batteries is approximately six (6) months
depending on the frequency of use.
4.1.3 Program codes are not lost when batteries are removed for
replacement. However, codes may be lost within an hour if power
is not restored to the remote control (CAUTION: FACTORY
CODES ARE NOT LOST IF BATTERIES ARE REPLACED
WITHIN THE ONE (1) HOUR TIME FRAME. IF ONLY ONE (1)
BATTERY IS REMOVED, THEN THE ONE (1) HOUR TIME
FRAME STILL APPLIES.) To avoid corrosion, replace dead
batteries immediately. Never mix old batteries with new ones. The
remote control transmitter does not have a power switch. If no
function key is pressed within a short interval, power goes ‘OFF’
automatically to avoid wasting the battery.
