AI-HUB-03-x Installation Manual
Document # 540316, Rev IR, 03/2006
Page 6 of 12
3.0 Installation
3.1 Prior to Installation
3.1.1 During the design and layout of the aircraft cabin, careful
consideration of the location of this module is necessary. Some of
the items to be considered include:
•
Space
•
Available power supply
•
Environmental conditions (temperature, humidity, etc.)
•
Length of cable runs
3.1.2 The AI-HUB-03-x shall be installed to conform to the standards
designated by the customer, installing agency, and existing
conditions as to the unit location and type of installation.
3.1.3 Mounting screws are required to secure the unit. Refer to
Section 6.0, Reference Drawings, for mounting hole diameters and
configuration.
3.2 Unpacking and Inspection
3.2.1 Carefully open the packaging and remove the AI-HUB-03-x. Verify
that all components have been included in the package per the
packing list. Inspect the unit for shipping damage.
3.2.2 If damage has occurred during shipping, a claim should be filed
with Audio International WITHIN 24 hours and a
Return Request
Authorization Number
shall be obtained from AI by contacting the
Repair Department at 501.801.0640. Repackage the unit in its
original packaging materials and return it to AI following instructions
given by the AI representative. Refer to the front cover of this
manual for address. If no return is necessary, retain the packing
list and the packing materials for storage.
3.3
Cautions and Warnings
3.3.1 It is important to do a pin-to-pin power and ground check on all
connectors. Ensure that power and ground are applied only where
specified. Damage to the unit may result if power or ground is
applied to the wrong points.
3.3.2
DO NOT
connect or disconnect the module while power is applied.
3.3.3
DO NOT
remove any factory-installed screws. Damage to the units
may result and void any warranties.
