Audio Control Architect 100, Руководство по установке

Страница: 8 / 26

®
Note: When the Signal-
Sense is turned on, then
the channel LED will not
turn on until there is an
audio signal present on
that channel’s input.
4
A Guided Tour Of
The Architect
tm
Model 100 and Model 200
Front panel:
Model 100 and Model 200
Ê
Stereo Speaker Optimizer controls
(Model 200 only) - This array of knobs provide
up to 12dB boost or cut at 45Hz, 150Hz,
300Hz, 700Hz, 2500Hz and 12KHz. After
initial adjustment the only time you would
change the control settings are 1) if you connect
different speakers into the system, 2) if (assum-
ing the speakers aren’t built-in) you move them
significantly, such as from a bookshelf to floor
stands, or 3) if your room acoustics change
through addition or rearrangement of furniture,
wall or floor coverings, large hairy dogs, etc
.
Ë
Channel Status LED’s - These dual-color
LED’s serve two purposes. First they illuminate
Green when the corresponding channel is active.
The second function of the status LED is to
turn Amber if something
has caused that zone to
go into protection.
Ì
Protection LED - This LED also has two
faces. In normal operation it glows Green when
the remote power trigger is active and the
Architect is in stand-by. If the Protection LED
turns Amber, then one of the internal protection
circuits have come into use. All the protection
circuits automatically reset themselves when the
problem causing the fault has been fixed.
Í
Power LED - Nothing too tricky here...when
you have the Master Power switch on the back
panel turned on and The Architect is plugged
into an active AC outlet, this little red light will
shine forth.
Model 100
Model 200
Ê
Ë Ì Í