6
4.0 INSTALLATION
• Before installing the HCX-11 Extender, connect the HDMI source directly to the
display using a short, high quality HDMI cable. This precaution is to verify that
the display is compatible with the source, and that the source is producing a
resolution that the display can accept.
• About “Power Mode”: In applications involving cable runs of 150 feet or less, the
receiver may be powered through a fifth coaxial cable from the transmitter, with
no power supply
connected to the receiver. Cable runs over 150 feet must be
four coaxial cables, with a power supply for both units (shown).
5.0 CONNECTING THE HARDWARE
• Turn off the HDMI video source and the HDTV display.
• Connect the source to the transmitter with a high quality HDMI cable no longer
than three feet for 1 bit signals, or 9 feet for 8 bit signals (see page 5).
• Install and terminate four, identical length, RG-6 or RG-59 cables (install five
cables if using internal power). Mark all coaxial cables on both ends before
installation to avoid hookup mistakes.
TRANS-
MITTER
RECEIVER
HDMI SOURCE
HDMI
CABLE
HDMI
CABLE
COAXIAL CABLES OVER 150 FEET
(FOUR CABLES REQUIRED)
HDMI
DISPLAY
POWER
POWER
