2048 Mercer Road, Lexington, KY 40511-1071 USA
800-322-8346 • 859-233-4599 • Fax: 859-233-4510
[email protected] • www.audioauthority.com
752-666 Rev. 20180115
Button (PSB) Ports
In switching mode, customers can activate one product at
a time using a two-wire momentary switch (push-button
sold separately). Connect a button for each corresponding
product. The LED in the button illuminates during the
demonstration. Buttons are not used in distribution mode.
Theft Detection
1710A theft detection is compatible with most headphone
models, including models with active circuitry such as noise cancelling. Activate
theft detection using feature switch #3. The 1710A can detect most headphones
when connected directly to the 1710A. If not, you must connect the product
through an Audio Authority extension cable. All devices should be tested for proper
detection behavior upon installation. If detection does not work for a particular
device, disable detection for that port using the Theft Detection switches.
Attach a reset switch (contact closure) to reset the alarm. We recommend that
a remote theft indicator light should be installed in clear view of customers. The
blinking LED is a deterrent, warning that theft detection is active. The on-board
buzzer sounds if it detects an unauthorized removal, but If a louder alarm is
desired, the external siren port can power a 12VDC siren.
When active, the theft indicator blinks and the 1710A detects the headphones that
are connected, so that it will trigger the alarm if one is removed. The theft indicator
light connected to the 1710A where the stolen headphones were connected shines
solid until the alarm is reset.
When headphones must be connected and disconnected, turn on the siren reset
switch, make product changes, and turn the switch off again. The theft indicator
LED(s) turn off when the reset switch is on. Only one reset switch is needed per
system; reset status is communicated to all other modules that are connected via
System Bus.
Timeout Interval
In switching mode, a demo timer is initiated each time a customer selects
a product output to audition. The demonstration length is set by the timeout
switch, in increments of 15 seconds. If the timeout switch is set to 0, then the
demonstration does not time out.
Operation
On power up, the status light blinks to show normal operation, and selector
buttons are lit. When customer audio is playing, the Status light blinks rapidly.
PUSH-BUTTONS ARE
AVAILABLE IN MANY
STYLES AND COLORS.