Audio Analogue Cinecitta, Руководство пользователя

Страница: 19 / 48

Configuration of the Processor
The Cinecitta’ Processor is an extremely versatile equipment. Obviously, the available
functions on the front panel or on the remote control allow to access the most used
operating functions, but not the configuration parameters. To customize the configuration
of the equipment it is available a complete set up accessible from the front panel, or
from the remote control. This set up is shown both on the display of the front panel
and on the video exits on the (OSD) on-screen display.
The configuration is contained in a non volatile memory and is maintained even when
the equipment is not supplied. The set-up is organized in sections and sub-sections
according to the functionality of every parameter. Exists, therefore, an ‘audio’ section,
a video’ section etc. For every sub-section, the relative voices are grouped in a menu.
For a optimal set-up navigation, this manual will show, for every menu, the function
of each voice.
Activation of the set-up
The Set-up is recalled pressing the button “MENU” on the remote control or pressing
at the same time the buttons” Analog Tape” and “ Digital Tape” on the front panel of
the Cinecitta’ processor.
Navigation of the setup
Because of the limited space, on the front panel’s display appears only a menu function
at the time; whilst on the OSD are visualized 8 voices at the time. For this reason, and
even for slipping the various voices, to select the chosen one, and also to modify the
values of the various values of the visualized parameters, it is possible to navigate the
set up both from the front panel and the front panel.
Testing sequentially the different menu functions
In the OSD, one of the menu functions visualized is enhanced: it is the funcion to be
selected. On the display, on the front panel, the function to select, is always the one
shown. To underline another function on the OSD menu and change the one shown
on the display it is possible to use left selector on the front panel or the buttons “Up
Arrow” or “Down Arrow” on the remote control. When in the OSD menu you try to
enhance a voice proceeding the first one which has been visualized or follows the last
visualized, the menu function pass to the high or low displaying the other available
menu functions.
Selecting the enhanced function of menu
You can select a function menu pressing the button “Analog Tape” on the front panel
or on the button ENTER on the remote control.
Modifying the value of a numerical parameter
To change the value of a numerical parameter evidenced, use the left selector on the
front panel or the buttons “Right Signal” and “Left Signal” on the remote control. If
the enhanced parameters are 2 ( as in the case of time and timer regulation), use the
left selector on the front panel or the buttons “Left Signal” and “Right Signal” on the
remote control for the displayed shown on the left, use the right selector on the front
panel or the buttons “Signal up” and “Signal down” on the remote control for the
parameter shown on the right.
Menu Exit
The menus whose functions connect to other menus always show the word END.
Selecting this word you can go back to the previous menu. Selecting END on the main
menu you finish the setup. The menus, which allow the choice between a range of
values of a parameter and a direct exit: selecting a function you can modify the
parameter and you go back to the previous menu.
Emergency set up exit
It is possible to leave the set up from any menu pressing the button “RTN”. If we are
in a direct choice menu, obviously the related parameter is not modified.
19