Audio Analogue Cinecitta, Руководство пользователя

Страница: 17 / 48

Stand-by
The Cinecitta’ processor can be put on stand-by pressing the button on the remote
control. When the processor is in stand-by all the exits are deactivated, the trigger is
off and the display shows the time. To remove the stand-by it is possible to act use
again the remote control. Alternately, it is sufficient to act on one of the checks of the
front panel: the equipment will remove immediately the stand-by.
It is advisable to put the Cinecitta’ processor on stand by when you don’t use it. The
analog circuit will remain on and in temperature, therefore in a condition to give the
best performance, whilst the video circuits and the decoding video circuits will have
to be deactivated and kept to a room temperature, to guarantee a longer duration of
the equipment.
Display brilliance
The intensity of the text’s brilliance shown on the display can be regulated cyclically
via remote control on four different levels.
Automatic memorization of the functioning condition
It is good to remember that the Cinecitta’ Processor memorizes the various values of
the functioning parameters which have be set up from the user: Volume, mute state,
inputs selected for the listening and for the recording, decoding ways, brilliance of the
text on the display, etc. This function is useful, because it avoid to the user the
reconfiguration of the equipment when it is switched off and then switched on, or put
in stand –by and then reactivated. To avoid bad surprises about the sound, especially
at night, it is advisable to reduce the volume, wait for few seconds to make sure the
memory updating occurs, switch off the equipment at the end.
17