Audi R8 LMS 2018, Руководство пользователя

Страница: 37 / 113

300 – Gearbox, Drive Shafts and Ancillary Components
Version 1 2016-01-01
37 / 113
c) Oil Quantities
3.2 litres when oil cooler and oil pipes empty (initial fill when new or after
rebuild).
2.9 litres when oil cooler and oil pipes full (service and maintenance work).
Changing the filter and oil is mandatory after 500 km with a new car and with a
new gearbox. Otherwise, oil and filter change during service or after a maximum
of 6,000 km.
d) Oil Level Measurement
1. Position the car on a level, flat surface
2. To measure the oil level, remove the oil dipstick, wipe dry with a
clean cloth. Afterwards, screw the oil dipstick by hand to the final
position, then remove and check the oil level.
3. After the warming up procedure (tgear – 60°C), the oil level should
be immediately below the ‘MAX’ mark on the oil dipstick.
Attention
If the oil level is too high and/or the car is driven when the gearbox oil
temperature is too low, it is possible that a significant amount of oil will be
discharged from the gearbox breather!
e) Inspection
There are four inspection openings available (A/B/C/D).
The condition and wear of the dogs on the gears and dog rings, and the teeth on
the fixed gears, idler gears, crown wheel and pinion can be checked visibly.
The wear of the above-mentioned components should be checked regularly.