Bluetooth
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
9
9
0
0
*
*
#
#
<30 cm>
Pairing
9
Pairing the headset
®
To use the headset with a Bluetooth enabled device for the first time, you must
pair the headset with that device, for example , a mobile phone.
Different devices may require different pairing procedures. The pairing procedure
for the headset is described in this User's Guide. Please refer to the user's manual
of the other device(s) for specific pairing method.
To complete pairing , you need to enter the correct passkey when required by the
other device during pairing.
To pair the headset with the device:
®
1. Activate the Bluetooth function in the other device if necessary. Please refer
to the user's manual of the device.
2. Turn the headset off first. Press and hold the multi-function button of
the headset for 8 seconds until the indicator lights on the headset
alternately flash green and red. The headset is now ready for pairing.
Make sure the headset and the other device are not too far
apart (i.e. 30cm or less).
Pairing the headset (cont.)
®
3. Initiate Bluetooth pairing in the other device to pair it with the headset .
Please refer to the user's manual of the respective device for specific
operation procedures. Once the headset is detected, a message will be
displayed with the following information:
4. When asked by the device, enter the headset passkey and then confirm
if necessary. If pairing is successful , the headset indicator light flashes
green and the headset is now ready to use.
5. If no pairing is possible for a period of time (approx. two minutes), the
headset will automatically turn off. Previous pairing (if any) remains.
You may need to repeat steps 2 thru 4 until pairing is successful (Note:
®
for Bluetooth enabled mobile phones, it is recommended to reset the
phone by turning it off first).
6. You can abort pairing any time by pressing and holding the multi-function
button for about 2 seconds until the red and green lights go off and
the headset is now turned off. Previous pairing (if any) remains.
“Audex-2383”.
Pairing
10
8 seconds
Adjusting the volume
During a call, the volume can be increased with the volume button,
which will be accompanied by a short tone. When the volume is at
maximum, you will be alerted with two short tones.
When reducing the volume with the volume button, there will be a
short accompanying tone. There will be two brief tones when the
volume is at its lowest level.
11
Low
High
