11
Rear Panel overview
Rear panel description
AC Power inlet with fuse:
The mains power supply (100~240 V AC / 50~60 Hz) has to be applied to this AC power
inlet. The connection is made by an IEC C14 power connector and is fitted with a fuse. When
replacing the fuse, make sure that the value of the replacement fuse matches the value of
the original fuse. (T0.5AL/250V)
RS232 Connection:
The RS232 connection can be used to control the system through any external hardware
such as home and industrial automation systems. The pinout and communication settings
are described in an earlier chapter of this user manual. The complete RS232 command
instruction set and configuration information can be downloaded from the AUDAC website.
USB (Update) Connection:
The USB (Update) connection can be used for system firmware updates and/or for connection
of the RF remote control (RMT40) receiver.
Balanced stereo line output:
The balanced stereo line output is implemented using two 3-pin terminal block connectors.
The audio output available on this connector allows it to be fed to any amplifier or pre-amplifier.
F-type antenna connection:
The antenna (input) connection is implemented using an F-type connector whereto the
supplied FM antenna should get connected. Depending of the installation conditions, location
and signal strength, it can be recommended / necessary to extend the antenna using 75
Ω
coaxial cable and connect an external or outdoor antenna.
