13
13
13
13
Special functions
When using one of these special functions, all the routing leds on the front of the R1 will blink a
couple of times to indicate the functions is being processed. When the blinking stops, the function
has been processed and you can release the pressed buttons.
Save settings
Routing settings can be saved by pressing simultaneously the buttons on ‘Zone 7’ and ‘Zone 8’ on
the front panel of the R1. Hold down the 2 buttons for about 10 seconds.
Recall settings
Recalling the saved routing settings can be done by pressing simultaneously the buttons ‘Zone 5’
and ‘Zone 6’ on the front panel of the R1. Hold down the 2 buttons for about 10 seconds.
Enable or disable the routing buttons
The routing buttons (Zone 1 to Zone 8) on the front panel of the R1 can be disabled by pressing
together the buttons of ‘Zone 3’ and ‘Zone 4’. Hold down the 2 buttons for at least 10 seconds.
To enable the routing buttons on the front panel of the R1, press down the ‘Zone 3’ and the
‘Zone 4’ buttons simultaneously for at least 10 seconds.
Reset to factory settings
To reset the R1 to the original factory settings, hold down the “Zone 1” and “Zone 2” buttons for
at least 20 seconds.
The R1 will restart, the “wait” led will go on and after about 30 seconds the green “run” led will
light up. The R1 settings are now restored to the factory settings, this means the IP-address will be
reset to 192.168.0.181 (subnetmask 255.255.255.0) and all previously saved settings will be lost.
REMEMBER
If you do not save the routing settings, the next time the R1 starts up, it will recall the
standard or previously saved settings !!!!
