AuCom CSX-007, Руководство пользователя

Страница: 1 / 12

710-02407-00G CSX Page 1
USER MANUAL
1.1 Caution Statements
Caution Statements cannot cover every potential cause of equipment damage but can highlight common
causes of damage. It is the installer's responsibility to read and understand all instructions in this manual prior
to installing, operating or maintaining the soft starter, to follow good electrical practice including applying
appropriate personal protective equipment and to seek advice before operating this equipment in a manner
other than as described in this manual.

Isolate the soft starter completely from the power supply before attempting any work on the starter
or motor.

Cables to the control inputs must be segregated from mains voltage and motor cabling.

Some electronic contactor coils are not suitable for direct switching with PCB mount relays. Consult
the contactor manufacturer/supplier to confirm suitability.

Do not apply incorrect voltages to the control input terminals.

Do not connect power factor correction capacitors to the output of CSX soft starters. If static power
factor correction is employed, it must be connected to the supply side of the soft starter.
The examples and diagrams in this manual are included solely for illustrative purposes. The information
contained in this manual is subject to change at any time and without prior notice. In no event will responsibility
or liability be accepted for direct, indirect or consequential damages resulting from the use or application of this
equipment.
WARNING - ELECTRICAL SHOCK HAZARD
CSX soft starters contain dangerous voltages when connected to mains voltage. Only a competent
electrician should carry out the electrical installation. Improper installation of the motor or the soft
starter may cause equipment failure, serious injury or death. Follow this manual and local electrical
safety codes.
GROUNDING AND BRANCH CIRCUIT PROTECTION
It is the responsibility of the user or person installing the soft starter to provide proper grounding
and branch circuit protection according to local electrical safety codes.
SHORT CIRCUIT
CSX soft starters are not short circuit proof. After severe overload or short circuit, the operation
of the soft starter should be fully tested.
Ce manuel est également disponible en français à partir de www.aucom.com.
Dieses Handbuch ist auch in deutscher Sprache aus www.aucom.com.
Questo manuale è disponibile anche in italiano da www.aucom.com.
Este manual también está disponible en español a partir de www.aucom.com.
该手册也可在中国从 www.aucom.com.
© 2007-2008 AuCom Electronics Ltd. All Rights Reserved.