Figure 27b. Bend the wire for easier insertion
.
5)
Install a cable tie as strain relief. Place a cable tie at 1.5 to 2 inches away from the back of
the controller (make sure the tie is not too close to the back terminals, otherwise, the cable
will have no room to bend). Cut off the tail of the tie as shown in Figure. 28. This tie will
function as strain relief to preventing the wire being pulled off the terminal.
.
Figure 28. Install a cable tie as strain relief (red arrow)
6)
Install the controller to the box. Screw the front panel first. Make sure the surface of the box
with double sided tape is on top of the controller. Then, gently pull out the cable from the
back panel of the box until it is stopped by strain relief. Screw on the back panel. Make sure
20
