AU DIGNO Tab, Заметки по использованию

Страница: 13 / 24

- 12 -
How to close the au IC Card (SIM Card)/microSD memory card tray
Insert the au IC card/microSD memory card tray in the product, and push in all the way
level with the ground and without bending.
After inserting the tray,
①
press all of the tray with the flat part of your finger.
②
Rub your
finger over the tray in the direction of arrow to ensure that the tray is not partially open.
Rub your finger over the tray in the direction of arrow to ensure that the tray is not partially
open.
①
②
●
If any liquid other than plain water gets on the product
• If anything other than water (seawater, washing detergent, soft drink, alcoholic beverage,
etc.) gets on the product, immediately rinse with water.
• A soft cloth may be dabbed with foaming hand soap, isopropyl alcohol, ethanol, or sodium
hypochlorite and used for wiping.
* For product care, refer to "Caring for the Product" (
▶
P. 13).
• Wash with slightly weak running water (less than 6 liters/ minute) with tap water (5
℃
to
35
℃
) at a position about 10 cm away from the faucet or shower.
• If the product gets soiled, wash by hand without using a brush, etc., holding the product so
that the au IC card/microSD memory card tray does not open.
●
After the product gets wet
• After becoming wet, drain water and wipe the product with a dry, clean cloth.
• In cold regions, any water on the product may freeze. Using the product with frozen water
may cause malfunction. Do not leave water drop on the product.
● Rubber seal
• The rubber seal around the au IC card/microSD memory card tray is important in
maintaining water resistance. Do not scratch or remove it.
• Be careful not to pinch the rubber seal when closing the au IC card/microSD memory card
tray. Trying to close the tray with a seal pinched can scratch the seal and affect water
resistance. Any minute particles becoming lodged between contact surfaces (a single hair,
etc.), no matter how small, can cause seepage.
• Any liquid other than water on the product can affect product durability.
• Do not insert pointed objects in the au IC card/microSD memory card tray. Doing so may
damage/deform the product or scratch the seal, allowing water seepage.
• Parts used for maintaining water resistance should be replaced every 2 years regardless of
their appearance. Contact your nearest au shop/au Style for replacement.
●
Heat resistance
• Do not submerge the product in hot water or get it wet with hot water. Do not use the
product in saunas or expose it to hot air from hair dryer etc. Product is not designed to be
heat resistant.
●
Dust resistance
• If dust gets on the product, immediately rinse with water and completely remove any dust
before using the product.
●
Shock from droppage
• While the product is resistant to drop, it is designed with drop resistance for normal daily
use; note that product may break if subjected to excessive force such as being thrown or
dropped unreasonably.