pg. 8
Notes: - All brand names and trademarks are properties of their respective holders and are referred to here for descriptive purpose only.
Photo attached is for reference only, it may be slightly varied in items of colour, shape from the actual item delivered from time to time
.
All specifications are subject to change without prior notice.
© Copyright ATZ 2016
Model : ATZ VGA-EM100IR-RX
Description: HDMI4K/VGA over IP Receiver with IR, RS-232, PoE/ LAN &
USB/KVM Extension
Note: Due to the nature of streaming video and HDCP, the switch may take up to
6–10 seconds to complete.
(b) Video Mode: Press and hold this button for 3 seconds to toggle the video data
streaming method between “Graphic” and “Video” modes. “Graphic” mode is optimized
for high-detail static displays and “Video” mode is optimized for full motion video
(7) CH+/LINK: This button controls multiple functions:
(a) C: Press this button momentarily to increase the streaming
channel to the next available channel on the local network.
Note: If no other channels are detected, the channel number will not change.
(b) Video Link: Press and hold the button for 3 seconds to enable or disable the Video
Link. When the link is disabled and the Receiver is connected to a display it will show
the system’s current IP and firmware information.
(c) Reset to Factory Defaults: Press and hold this button when powering the
unit on until both the POWER and LINK lights are blinking. Once both lights are
blinking you can reboot the unit and all settings will be returned to the factory
defaults (Including resetting the IP mode to auto, broadcast channel to 0, and the
streaming mode to multicast). A new IP address will be assigned automatically
within the 169.254.xxx.xxx address range.
(8) CH−/USB: This button controls multiple functions:
(a) Channel −: Press this button momentarily to decrease the streaming channel to
the previous available channel on the local network.
Note: If no other channels are detected, the channel number will not change.
(b) USB: Press and hold the button for 3 seconds to enable/disable the USB
connection between the Transmitter and the Receiver. (Multicast Mode ONLY)
Note: In Multicast mode is it only possible to provide USB support to a single Receiver
at a time. Enabling USB on one Receiver will disable it on all other Multicast Receivers
on the same channel.
(9) IR WINDOW: Accepts IR signals from any standard remote control
and sends the signal to the IR Out on the associated Transmitter.
(10) IR IN: Connect to the provided IR Extender to extend the IR control range of
remotely located devices. Ensure that the remote being used is within direct line-of-