CHAPTER 2: PRODUCT DESCRIPTION
INSTALLATION
3. Installation
3.1. Installing Forward Path Amplifier
Each forward path amplifier module occupies two slots in the chassis. Use the following procedure to install modules in the
SignalOn Series chassis.
1. Make sure the ATX logo (or any other front panel lettering) is readable. Align the power connector at the top of the
module with the power connector in the chassis. Slide the plug-in module into its designated location in the chassis.
2. Secure the module using its two captive retaining screws. See Figure 13 or Figure 14.
3. After each module is loaded into the chassis, refer to your work order, and connect the designated RF cables to the
appropriate F connectors on the modules in the chassis.
4. Carefully route cables through the cable management slots located on each side of the rear of the chassis. Use the
cable management guidelines found in this manual to route cable from the chassis to the rack/cabinet.
5. Perform any cabling or operational tests required at your facility.
SignalOn
®
Series – Forward Path Amplifier Products – Installation & Operation Manual
3-1
CHAPTER 3: INSTALLATION
POWER CONNECTOR
(FACING CENTER
OF CHASSIS)
30 dB
AMPLIFIER
Figure #4: Amplifier Installation 2RU Chassis
