VIA KT133 ATX MAINBOARD
HARDWARE SETUP
3-21
Followings are the procedures to use JP9 to clear the BIOS setting which is saved in the
CMOS memory.
1.
Unplug the AC power cable from the PC system.
2.
Open the cabinet of the PC system.
3.
Put the mini jumper on pin 2-3 of JP9 around 3 to 5 seconds and then
return it to the original position ( pin 1-2 ).
4.
Close the cabinet
5.
Re-connect the AC power cable.
6.
Power on the PC system and then run BIOS setup program to
reconfigure the PC system.
Note: Improper BIOS setting may cause hang-up to the PC system, Should it be
happened, you may use JP9 to clear the information which is stored in
the CMOS memory and get the PC system back to normal. Improper
connection may cause permanent damage to the mainboard. Please refer
to the following steps to clear the CMOS
IMPORTANT:
After you have use JP9 and clear the setting which is saved in the CMOS
memory, we suggest that you use “Load Optimized Defaults” and have the
optimized parameters loaded into the BIOS setup program. Such
parameters were fine tuned and they will let you have the optimized
performance and stability.
