N-Way signal options set via DALI command 35
Using the Dali command 35 – several modes are available. A DALI command 35 with the following values will
select these advanced features. These settings override and disable the round programming button
0
THREE WAY
Default
2
Full Automatic
Turn on when presence is detected and the room is dark
3
Occupancy
Turn on when presence is detected
4
Vacancy
Manual turn on, turn off after a delay with no presence detected.
5
Ambient
Same as Occupancy, but only on if Ambient light is low
6
FAN
Force fan mode ( CV 12 volts)
Fan control
Intended for bathroom fans, if the B output is a light, and the light switch is turned on locally and stays on, then the
A output will be turned on for the Hold-ON duration. The delay before turn on is set by the DALI command 51, then
once on, the on time is set by the DALI command 52. If the light stays on, the fan stays on past the Hold-On time
DALI
Function
Set DTR value before these commands
Scale
50
Fan Idle
Sets the speed of the fan when it is ‘off’ – can set a low level
20-200
51
Delay before ON
∞
,
7, 10, 14, 20, 28, 40, 56, 80, 113, 160, 226, 320, 452, 640, 900 Seconds
0 =
∞
15=900
52
Hold-ON
∞
,
½ , ¾, 1, 1 ½ , 2, 3, 4, 5, 8, 10, 15, 20, 30, 40, 60 Minutes
0 =
∞
15=60
53
Fan Operate
Sets the speed of the fan when it is ‘on’
50-254
∞
means never. The A output can also be controlled by a simple contact switch connected to the N-Way input.
The N-Way switch overrides the timers. Note: Set mode 35 to FAN to set Delay and Hold. Set mode 35 to 0 to set
lamp fade rates – then change to Fan mode to set Delay and Hold
