69
3.8 Resetting to the factory default settings
To reset the Network Camera to the original factory settings, go to the Setup>System> Maintenance
web page (described in “3.5.6 System > Maintenance”) or use the Reset button on the network
camera, as described below:
• Using the Reset Button
Follow the instructions below to reset the Network Camera to the factory default settings using
the Reset button.
1. Switch off the Network Camera by disconnecting the power adapter.
2. Remove the rear cap of the camera.
3. Press and hold the Reset button with a straightened paperclip while reconnecting the power.
3. Keep the Reset button pressed during about 2 seconds.
4. Release the Reset button.
5. The network
camera
resets to factory defaults and restarts after completing the factory reset.
The unit now has the default IP address 192.168.30.220.
6. Close the rear cap of the camera.
Caution: When performing a Factory Reset, you will lose any settings you have saved.
