Running operation
There are two working mode to select in this equipment, which are
"Solder"
and
"Repair"
. The mode
“Solder”
is designed to solder the circuit
board components, the whole process are
“PREH”
(warm-up),
“HEAT”
(heating),
“SLDR”
(solder),
“KEEP”
(heat preservation) and
“COOL”
(wait
for the machine to cool down); the mode
"Repair"
is designed to dismantle
circuit board components, there is only one temperature setting segment.
Before you enter the working mode, make sure the parameters whether right or
not.
You must set the parameter of the machine when you first time use it or the
tin pulp formula has been changed. You also can change the language Chinese
or English which you want.
1. power on
Turn on the main power switch back of the instrument, on the left top of the
display have red light lighted, then press the key
“ON/OFF”
on the panel, to
enter the standby state, as shown in figure “Fig 3”
、“
Fig 4”
Fig 3
：
Fig4
2. System setting
Turn on the main power switch and then press the key
“RUN”
first while
pressing the key
“ON/OFF”
, to enter the system setting mode. As shown in
