ATSG AX4S, Обновление руководства

Страница: 101 / 120

Copyright © 2002 ATSG
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
101
Figure 87
SHIFT SOLENOID 1:
SHIFT SOLENOID 2:
SHIFT SOLENOID 3:
TURBINE SPEED SENSOR:
MANUAL LEVER POSITION SENSOR (MLPS):
Wires for Shift Solenoid 1 are fed through pins 5 and 6 of the "White" case connector, located on the side of
transaxle (See Figure 88). Ohmmeter across terminals 5 and 6 should read 12-30 Ohms resistance.
Wires for Shift Solenoid 2 are fed through pins 1 and 2 of the "White" case connector, located on the side of
transaxle (See Figure 88). Ohmmeter across terminals 1 and 2 should read 12-30 Ohms resistance.
Wires for Shift Solenoid 3 are fed through pins 3 and 4 of the "White" case connector, located on the side of
transaxle (See Figure 88). Ohmmeter across terminals 3 and 4 should read 12-30 Ohms resistance.
The Turbine Speed Sensor is located on the channel plate next to the left hand axle seal. With Ohmmeter
across the two terminals of the TSS, there should be 100-200 Ohms resistance.
The Manual Lever Position Sensor is checked across pins 2 and 3 of the sensor as shown in illustration below.
With Ohmmeter across pins 2 and 3 the resistance reading should correspond to the chart below.
Lever
Position
Ohms
Resistance
P ---------------------------------------- 3769-4608
R ---------------------------------------- 1303-1594
N ---------------------------------------- 660-807
D ---------------------------------------- 361-442
2 ----------------------------------------- 190-232
1 ----------------------------------------- 80-95
5
6
7
8 1
2
3
4
(View Looking Into MLPS)