3/17/2008
4248-301-900 - INST
2
4.
Remove transmission fluid drain plug and allow fluid to drain.
5.
Once fluid has drained completely (fluid drips every 1 to 2 seconds)
replace drain plug and remove the 12 bolts holding factory transmission
pan in place. Remove pan and gasket.
6.
Remove transmission fluid filter.
Figure 2: Factory Transmission Pan and Filter Assembly
7.
Prior to installing new transmission filter, make sure that old fluid filter
seal has been removed. Install a new fluid filter and seal assembly.
8.
Clean gasket surface on transmission and transmission pan. Apply a ¼
in. wide bead of silicone/gasket maker to transmission pan around seal
surface. The Right Stuff® gasket maker is a good choice and provides
an instant seal.
9.
Align ATS High Capacity Transmission Pan with bolt holes in
transmission. Thread new stainless steel cap screws in transmission
until finger tight. Torque all cap screws to
20 ft-lbs
in a crisscross
pattern.
Transmission Filter
Gasket
Factory
Transmission Pan
Transmission
Filter Seal
Drain Plug
