Atronic Harmony Upright, Руководство по установке

Страница: 17 / 24

17 June 2008
Harmony™ Installation Manual
MACHINE INSTALLATION
Machine Mounting
Caution! Tipping Hazard
Do not operate the machine unless it has
been properly secured with an Atronic In-
stallation Station (AIS). The machine can
tip over, if it is not properly mounted to a
solid base.
1. Use the Atronic Installation Station (AIS) drilling
template, supplied by Atronic, to mark the holes
on the base before drilling. Make sure to leave min.
180mm (7.1") distance to the next machine or a
wall on both sides of the cabinet.
If the drilling template is not at hand, use the
drawing on the next page.
2. Drill four holes 10mm ( 3 /
8
") for the AIS mounting
(drillings a) and one out of three holes 10mm ( 3 /
8
")
for the machine securing bolt (drillings d) into the
base. It is not important which of the 3 holes for
the securing bolt is used, if at least one securing
bolt is mounted. If the base stand has braces or
struttings placed below one mounting hole, simply
use another one.
3. Drill or cut out one 55mm (2¼") hole for threading
the mains cable into the base (drilling b).
4. Cut out the 60 x 50 mm (3¼") coin drop recess
for into the base stand
(recess c)
5. Secure the AIS to the base using 4 mounting bolts
and fasten with washer and wingnuts.
Make sure that the boltheads are completely
lowered into the counterbores of the AIS.
M
ACHINE
I
NSTALLATION
b
c
a
d