THIS APPLIANCE IS INTENDED FOR COMMERCIAL USE ONLY.
SERVICING, OTHER THAN NORMAL MAINTENANCE, MUST BE DONE
BY AN AUTHORIZED SERVICE REPRESENTATIVE.
VACO22VDC, PMP22VDC OPERATION INSTRUCTIONS
1.
Release the two front fasteners and open the lid.
2.
Remove hose and attachment from cover storage area.
3.
Remove the orange plug from the filter cartridge and store in unit.
4.
Slide one end of the super flex hose into the filter cartridge.
5.
Attach appropriate accessories on the hose assembly.
6.
Insert Battery into battery receptacle.
7.
Close lid and latch securely.
8.
Turn on the power switch.
9.
These vacuums have a factory installed resettable Thermal Cutout (TCO) for added
operator and motor safety. If the unit gets too hot, the vacuum will shut down.
Please check your hose and utensil for clogs or obstructions. In addition, it may be
time to install a new filter. After checking all the above, please turn vacuum back
on.
FILTER CHANGE-OUT INSTRUCTIONS
Your Omega Cordless includes a full filter indicator light underneath the on/off switch.
This indicator is a guide to provide a visual of when it is time to consider removing the
filter, disposing and inserting a new filter
.
1.
Release the two front latches and open the lid.
2.
Insert orange plug halfway in contaminated filter cartridge.
3.
Lift the filter cartridge out by placing fingertips under lifting tabs located on the
ends of the cartridge and lift up.
4.
Push orange plug all the way in.
5.
Dispose of the filter cartridge in an appropriate manner compliant with all local,
state, and federal laws.
6.
Insert new filter cartridge.
7.
Close lid and latch securely.
Your Omega Cordless can be configured to allow its use in and around static sensitive
devices by doing the following:
1.
Use *31671STUD hose.
2.
Attach *510-001-006 ground cord to hose.
3.
Attach other end of ground cord to a known ground or machine ground OR Attach
the banana jack into the *SSISP-101 Statguard and plug into 110V wall outlet.
4.
Attach any ESD Safe Utensil to your hose.