6
1.2
Unpacking your phone
In this package, you will find:
Aton CL101
Aton CL101 Duo
Aton CL101 Trio
1 base station
1 handset
1 230 V adopter
1 phone cable
3 NiMH AAA
1.2V, 550 mAh batteries
1 trilingual user guide
1 base station
2 handsets
1 230 V adopter for the base
station
1 power supply unit 230 V
for your additional battery
charger
1 phone cable
6 NiMH AAA
1.2V, 550 mAh batteries
1 trilingual user guide
1 base station
3 handsets
1 230 V adopter for the base
station
2 power supply units 230 V
for your additional battery
charger
1 phone cable
9 NiMH AAA
1.2V, 550 mAh batteries
1 trilingual user guide
2
Setting your phone
Sitting the phone
The phone must be sited at least one metre away from all other electrical appliances.
Operating distances
Your Aton CL101 base station and handset both transmit and receive radio signals. The
propagation distance depends on the location of the base station. Placing the base station high
up will ensure an optimal operating distance.
Inserting the batteries
1.
Insert the standard rechargeable batteries into the designated compartment. Take care to
ensure that the polarity is correct. Therefore the corresponding symbols are engraved.
2.
Unpack the compartment cover of the casing and close it by sliding it upwards.
Please note: When the battery is low, you will hear an alarm tone every 30 seconds and the
battery symbol will flash. When you place the handset on the base to charge it, the battery
symbol will be animated:
When the battery is fully charged, the battery symbol will have three completely full filled stripes.
If the battery is empty you will see none of the tree strips.
We recommended that you completely discharge the battery once a week. This will increase the
lifetime of the battery.
A fully-charged battery will give you 10 hours of call time or 100 hours on standby.
Il is completely normal for the battery to become warm while charging. You should only use
replacement batteries that are identical to the one supplied with your Aton CL101. The use of
unsuitable batteries will invalidate your phone’s warranty and may cause irreversible damage.
Plug in the mains cable
Insert the plug of the power supply into the socket on the rear of the base station (The socket
has the symbol of a phone on it) and connect the other end with the telephone jacket.
1.
Insert the mains cable (the round cable) with the round socket on the rear of the base
station. Connect the plug of the power supply unit with a rear providing 230V.
Before using the phone intensively, the batteries have to be charged at least 12 hours.
Please note:
Your Aton CL101 does not function if you do not charge it with a power supply unit providing
230V.
