Atomik 18010, Инструкция по эксплуатации

Страница: 9 / 16

7
ATOMIKRC.COM 18010
Battery Installation
Installing the LiPo Battery in Your Boat
(Always turn on the controller before connecting the
battery to the ESC.)
1. Remove the hatch by turning the hatch latch at the rear.
2. Insert the battery into the left side of the hull. Take note
of the hook and loop material for proper battery placement.
3. Attach the battery connector to the matching
connector inside the model. Listen for three
continuous beeps. (Initializing tones of the ESC.)
4. Replace the hatch. Make sure the insert tab at the front
of the hatch keys into the hull.
5. Secure hatch by turning hatch latch until it clicks.
NOTE: 1. There is a rubber ring placed along the slot of the hull. Always make sure it is secured properly
before re-positioning the hatch. Kinks or breaks in the rubber ring will cause water to enter hull.
2. When you are not using the boat, remove the rubber ring from the hull. This will keep the rubber
ring flexible and help to ensure effective water-resistance for future use.
IMPORTANT: Always disconnect and remove the LiPo battery when not in use!
Beep 3x’s
Driving Your Boat
1. Preform all functions outlined in the Pre Run Checklist.
2. Switch “ON” the controller . Check that the controller’s red LED light glows brightly.
3. Switch “ON” the model by connecting the LiPo battery pack.
4. Check that the prop and rudder respond to the controller inputs before placing the boat in the water. Also
check to ensure prop and rudder and moving in proper direction.
IMPORTANT: Be sure to keep objects away from the spinning prop to avoid damage and potential
personal injury.
NOTE: If the prop is not spinning in the correct direction, unplug the battery and switch any two of the
motor to ESC connections.
After Use:
1. When you have finished using the boat, first switch “OFF” the model by disconnecting the battery pack.
Then switch “OFF” the controller.
2. Remove all batteries from the controller and model.
3. Drain any water that may have accumulated and leave the hatch off the boat to allow moisture to
evaporate.
4. Place the model in a safe, dry place until it is dry and then store it away.